Statori Yes, Hello and Well Done Piaggio
The stator is the beating heart of the electrical and ignition system of your Piaggio Ciao, Si or Bravo. It is the essential component that generates the current needed both to produce the spark at the spark plug and to power the lights, horn, and the rest of the system.
If your moped has starting problems, a weak spark, dim or non-functioning lights, the cause is often a defective or demagnetized stator over time.
In this section, you will find a selection of complete stators ready for installation, allowing you to fully restore the electrical efficiency of the engine. We offer both stators for point systems (for more classic models) and stators for electronic ignition, ensuring perfect compatibility. Choose the right spare part to restore energy and reliability to your Piaggio.
PINASCO ignition module conversion from points to electronic for Piaggio Ciao-SI-Bravo
Models with contact point ignition
For conversion to electronic ignition
Pinasco has created a control unit that converts engines with contact point ignition into engines with electronic ignition without needing to replace the original components. By eliminating the capacitor and connecting the control unit in parallel with the original high-tension coil, it is possible to carry out the conversion without invasive modifications to the engine or the electrical system; the contact points are not removed, they become the pick-up signal.
Polini ignition only for Piaggio mopeds originally equipped with electronic ignition
Yes-Hello-Good (only for models originally equipped with electronic ignition)
Rubber cable grommet magnet flywheel for CIAO-BRAVO-BOXER-SI' SINCE 1973
HELLO-BRAVO-BOXER-YES SINCE 1973
Ref.Orig: 131105
Stator plate coils (wide advance angle variation) for SI-Ciao-Bravo
Yes-Hello-Good
Wide advance angle variation
Simply by rotating the plate, without removing the flywheel.
Complete stator for Piaggio Ciao-Bravo-SI (models with indicators)
Hello-YES-Bravo
Ref.Orig: 2938145
Power ignition only for Piaggio mopeds originally equipped with electronic ignition
Yes-Hello-Bravo (only for models originally equipped with electronic ignition)
In the Power package, you will find everything you need:
Adapter ring to properly fix the stator to the crankcase
4-pole 12 Volt stator (90 watts). It is necessary to change all the original bulbs!
Lightened flywheel (mass 885 gr for a moment of inertia of 16.2Kg/cm2) made from a hot-stamped solid piece and designed to withstand even the highest rotation speeds!
Red plastic fan!
Dedicated ready-to-use wiring with output cable for battery charging or stereo connection, for original modifications!
Voltage regulator!
Hai visualizzato 6 di 6 prodotti