Cooling shroud for the thermal unit for Vespa 150 GS VS1>5T
In raw steel
Vespa 150 GS VS2T>VS5T
Related articles
Complete headlight with original Piaggio reflector for Vespa 125/150/200 PX MY
Vespa 125 PX CAT ZAPM50100 '07
Vespa 125 PX VNX1T Millennium '98>'05
Vespa 150 PX VLX1T Millennium '98
Vespa 200 PE VSX1T Millennium '98
Ape 50 MP
Ø barrel: 5.5mm
Wire measurements: Ø1.2mm x 3150
Racing Exhaust FURY S1 - for Vespa 125 Nuova VMA1T/125 Primavera VMA2T/ET3 VMB1T
Vespa 125 Primavera, Vespa 125 Primavera ET3
FURY S1 Handmade Racing Exhaust
This expansion is designed to be paired with the primary gears of 125cc Vespas, to exploit the engine's torque from the lowest revs with a pleasant sound.
It is ideal for long-stroke thermal groups such as: VMC Kappa 58, VMC CP-58, VMC GS and GSR 58 and 60mm, Kast GRV, Polini, Malossi, Pinasco, etc.
The exhaust manifold has a flange with slotted holes and fits stud centers of 52, 56, and 62 mm. The inlet diameter of the manifold to the cylinder is 32 mm. Calculated for phases around 120°/180°–185°, but also adaptable to wider ranges.
It does not fit on ET3 and Primavera frames with a side drawer. On PK frames, a part of the internal bulkhead supporting the spare wheel must be cut.
Mounting on cylinders with 52 mm stud centers may be difficult: it is recommended to use flanged nuts for a 10 mm key (code 003577).
After use, apply oil to
Metal cable tie for securing cables to engine cross member and intake bellows for Vespa 150/160/180 VS1>5T-VSB1T-VSC1T
Vespa 150/160/180 VS1>5T-VSB1T-VSC1T
In metal
The photo shows the clamp as produced, for assembly the two folded parts of the clamp go inside, tightening the bellows or the sleeve or the cables to the engine casing