Minimum jet for carburetor type VHST series S
Original reference: 16690
Vespa 50/90/125/150/160/180/200
Related articles
Vespa 50 V5A1T 500001>
In polished Aluminum, fastening with 3 pins
Primary HTQ couple with extended Malossi ratio (Z 24/63) for Vespa 200 PX-PE-Rally
Vespa 200 Rally VSE1T
Vespa P 200 E VSX1T
Vespa PX 200 E VSX1T
Vespa PX 200 E Rainbow VSX1T
Vespa PX 200 E Rainbow Elestart VSX1T
Vespa 200 PE VSX1T Millennium '98
Complete damper kit
Base ba15s
Primary transmission gear pair TOP Crimaz z22 on 72 bell with reinforced clutch basket and shock absorbers for Vespa 50/125 Special-Primavera-ET3
Vespa 50 V5A1T N,L,R
Vespa 50 PK
Vespa 90 V9A1T
Vespa 125 Primavera VMA1>2T
Vespa 125 Primavera ET3 VMB1T
The construction of the teeth is carried out with a module 1.5 gear cutter tool with relative corrections for the pinions added to the original pair.
The width of the tooth has been widened (1 mm towards the inside) to have greater resistance without compromising smoothness.
The spring seats have been revised to use springs with square wire. The greater stroke of the damper preserves the gearbox and the driveshaft.
In the center, there is a roller bearing on the most stressed part and a guide bushing on the shaft. This solution allows the bell to be compatible with the original starter gears.