
Gear shaft with 2 alignment holes for Vespa 50-90-125 Primavera/ET3/PK
The new reinforced rotating axle for Vespa smallframe engines is
made of ultra-high strength steel with vacuum carburizing treatment.
The material used and the new sizing make the shaft
particularly suitable for tuned engines or those with displacements
above the norm (even up to 250 ccm)
Today, thanks to recent investments by some manufacturers, it is
possible to find a wide selection of very powerful thermal units on the market
that even exceed 40 horsepower.
Remember that the Vespa smallframe engine was designed to last over
time and its power rarely exceeded 10 horsepower.
With these power increases, it is essential to adjust all the mechanisms to avoid breakages and premature wear.
Example of the new sizing. The threading has also been increased to M16x1.25
Vespa 50 V5A1T N/L/R 92877>
Vespa 50 S V5SA1T 111891>
Vespa 50 Special V5A2T>3T
Vespa 50 Special V5B1>4T
Vespa 90 V9A1T 25001>
Vespa 125 Primavera VMA1T>VMA2T
Vespa 125 Primavera ET3 144679>
Vespa 50/125 PK S/XL/N/HP

Gear tree assembly tool for Vespa 50-125/PV/ET3/PK50-125/S/XL/XL2/125 V1-GTR 2°/TS 2°/150 VL-Sprint V2°/Super 2°/PX80-200/PE/Lusso/'98/MY/'11/T5/Cosa
Vespa 50-125/PV/ET3/PK50-125/S/XL/XL2/125 V1-GTR 2°/TS 2°/150 VL-Sprint V2° /Super 2°/PX80-200/PE/Lusso/'98/MY/'11/T5/Cosa
M16x1.25, M14x1.5, M12x1.5, M12x1.25, RH M10x1.5, LH M10x1.5 mm
10 parts