The construction of the teeth is carried out with a module gear shaper tool 1.5 with relative corrections for the sprockets added to the original pair.
The tooth width has been widened (1 mm towards the inside) to achieve greater resistance without compromising smoothness. The spring seats have been revised to use springs with square wire. The greater travel of the damper preserves the gearbox and cruise. In the center, there is a roller bearing on the most stressed part and a guide bushing on the shaft. This solution allows the bell to be compatible with the original starting gears.
Approfondisci
Shipping time
24/48 hours
390,00 €
319,67 € VAT excluded
1 point RDV = 2 cents390 points RDV=7,80 € cashback