Hole center distance: 34 mm
MADE IN ITALY

Warehouse stock, while supplies last.
Original ELEDRO

Raw steel
Complete with crosspieces and reinforcements

Sheet thickness as original (1 mm)

Width: 42 cm

Length: 78.5 (including the curve)

WARNING: single piece, without welds

Diameter: 24 mm
Color: Gray
100% original design

It mounts without making modifications to the frame, also suitable for rotated cylinders

Variable advance 12v 90w
Connections: blue - to ground + to the small spade terminal of the control unit
red/black to the large spade terminal of the control unit + to ground for shutdown
yellow to the voltage regulator

Color: Black with Red spring

Including OR'ing

Two-seater, plastic base, with handle and lock

100% MADE IN ITALY

Notes: Very Comfortable

6 wires: Black, green, brown, purple, pink
Manufacturer: Grabor

Specification for Vespa model for long-lasting and maximum efficiency. Thanks to the greater number of copper coils, there is concrete support for the lighting system. Winding with DOUBLE FILAMENT.
Output wire colors true to the Vespa system.

Hole diameter mm 5.2
Hole distance mm 43
Thickness mm 13
Length mm 72

Technical characteristics:

Green Wire
Bare ground wire

1L Package

Dimensions: 25x62x12 mm
Ref. Orig. 097804

Luggage rack for the rear, in the style of the 1960s with a spare wheel holder in a horizontal position. This way, the luggage space is fully preserved despite the spare wheel. This transforms every PX into a real workhorse. Luggage rack surface: 43x25cm

NOTE:
The Michelin S83 is ideal as a spare wheel. Other tires may
be too wide and therefore may not fit in the holder.

Internal--->125mm

Thickness--->28mm

12Volt Alternating Current
Economical Version

Socket: ba15s

Weight: 3.7 gr.

With padded backrest and handles.
Attachment via tank bolts.

Hole spacing: 46 mm
Finish: Glossy
Included: 2 Fixing plates
Length: 84 mm

- increased wall thickness for greater resistance to mechanical stresses
- a very wide base support of the cylinder and a lot of material underneath, allowing for very generous transfer ports
- Bearing seat on the flywheel side with a seat diameter of 47 as in the Piaggio 50 Special and 125 Primavera ET3 versions

l=36 mm
Ø inner: 30mm
Ø outer: 37mm

kit composed of:

2 gear cables
1 clutch cable
1 front brake cable
1 rear brake cable
1 starter transmission

up to 150km/h
profile: classic
Ø 10"
with ECE standard

Diameter: 13mm

Smart MRP solution to continue drawing cold air from the frame when using larger carburetors.

The opening in the frame measures approximately 60x44mm. The area is therefore equivalent to a carburetor with a cross-section greater than Ø50mm. Thus, the intake pipe solution offers no performance loss even on very powerful engines. Thanks to the cooler intake air, better results can be expected under heavy load, which otherwise strongly heats the intake air under the side cover.

Another great advantage is that the frame can also be used as sound insulation. Engines that have been converted to diaphragm-controlled intake can thus drastically reduce the noise level of the intake air. For this purpose, the frame can be further lined from the inside with sound-absorbing material.

Ref. Orig. 610088M

Included rubber protection, screw, and bolt.

Lamp holder with 2 lights
Diameter: 135 mm
Transparent plastic