Filter dimensions: 145x145mm

Mount diameter: 55mm

Minimum jet-->38
Maximum jet-->84

Minimum flow-->36

Maximum flow-->104

Elastic attack with 35 mm graft

Included: Rubber sleeve, clamps, and gasket

Filter size: 80x63mm

Mount diameter: 35mm

Intake--> 28.5 mm
For PHBL 24 carburetors 

Measures from

Sleeve attack (diameter 34mm)
For carburetors PHBL PHBH -22 - 24 - 25 - 28

In Aluminum, 3 Holes

Complete with sleeve, clamps, and studs

For SI carburetors

The airbox for the original carburetor casing. Even the largest carburetor
is useless if it cannot draw enough air into a PX engine. The airboxes for the SI carburetor casings provide a remedy
here, as their significantly larger volume provides the engine with a
good 20% more air compared to the original carburetor casing cover. The engine responds much better, especially at
low revs.' of volume, suitable for models WITH mixer

Sleeve attack (diameter 35mm)
For PWK 28mm carburetors

For PWK/PHBL/VHST carburetors

Kit composed of 1 horn, foam filter, flange, and screws.

Diameter: 23 mm

Notes: for 19:19 carburetors

Material: Aluminum Application: For Carburetors 24:24
carburetor connection: 28.5mm
2 holes
rotary disc valve

Main feature: 3-hole flange
Suitable for 28 PWK carburetor

Sleeve fitting

Carburetor inlet--> 23 mm, 2 holes

Diameter: 21.5 mm

Elastic attack with 40 mm graft
Calibration: Max jet 122, min jet 42

In Aluminum, 3 Holes

Complete with sleeve, clamps, and studs

Carburetor connection--> 47 mm
Filter connection-->34 mm

Thread M6x1mm 
Internal hole: 3mm

Diameter: 24

Sleeve attack (diameter 35mm)
For PWK 28mm carburetors

Main feature: 3-hole flange
Required for "turned" mounting of the thermal unit

Warning: this manifold is designed for track use and is mounted with a modified and cut frame.

The manifold support has two holes and not three, one hole is not used.

For PWK/PHBL/VHST carburetors